We're so confident of our products that we provide no hassle product exchange.
Fortinet fortinet certified network security administrator Sample Questions:
1. Because changing the operational mode to Transparent resets device (or vdom) to all defaults, which precautions should an Administrator take prior to performing this? (Select all that apply.)
A) Update IPS and AV files.
B) Set the unit to factory defaults.
C) Backup the configuration.
D) Disconnect redundant cables to ensure the topology will not contain layer 2 loops.
2. Which of the following authentication types are supported by FortiGate units? (Select all that apply.)
A) Kerberos
B) RADIUS
C) Local Users
D) LDAP
3. In an IPSec gateway-to-gateway configuration, two FortiGate units create a VPN tunnel between two separate private networks.
Which of the following configuration steps must be performed on both FortiGate units to support this configuration? (Select all that apply.)
A) Define the Phase 2 parameters that the FortiGate unit needs to create a VPN tunnel with the remote peer.
B) Configure the appropriate user groups on the Fortigate units to allow users access to the IPSec VPN connection.
C) Create firewall policies to control traffic between the IP source and destination address.
D) Define the Phase 1 parameters that the FortiGate unit needs to authenticate the remote peers.
E) Set the operating mode of the FortiGate unit to IPSec VPN mode.
4. Which of the following items represent the minimum configuration steps an administrator must perform to enable Data Leak Prevention for traffic flowing through the FortiGate unit? (Select all that apply.)
A) Define one or more DLP rules.
B) Assign a DLP sensor in a firewall policy.
C) Define a DLP sensor.
D) Enable DLP globally using the config sys dlp command in the CLI.
E) Apply a DLP sensor to a DoS sensor policy.
F) Apply one or more DLP rules to a firewall policy.
5. The command structure of the CLI on a FortiGate unit consists of commands, objects, branches, tables and parameters.
Which of the following items describes port1?
A) A parameter.
B) A table.
C) An object.
D) A command.
Solutions:
| Question # 1 Answer: C,D | Question # 2 Answer: B,C,D | Question # 3 Answer: A,C,D | Question # 4 Answer: A,B,C | Question # 5 Answer: B |
By Kyle
